|
General Specifications |
|
| Operating Voltage: | 120 VAC, 60 Hz |
| Transformer: | UL listed, Class II, plug-in, 16 VAC, 1.25 A (supplied) |
| Back-Up Battery: | 4.0 Amp-hour, 12VDC (not supplied) |
|
RADIO RECEIVER
|
|
| Type: | superheterodyne |
| Operating Frequency: | 315 MHz , 125Kc |
| Sensitivity: | -100 dB minimum |
|
Antenna Type: |
3counterpoised bipolar design |
| Compatible RF Formats: | Linear DX, DXS |
|
CONTROL
PANEL
|
|
| Radio Zones: |
24 supervised
|
|
Hardwire Loops:
|
8 supervised |
| PAC Codes: | 8 total, including Duress, Installer, Paging, and 5 User |
| Operating Modes: | Off, Chime, Home, Home Instant, Away, and Test |
| Sensor Types: | 11 including Automation, Emergency, Panic, Fire, Perimeter, Exit/Entry, Interior, Chime Only, Arm/Disarm A, Arm/Disarm B, and Environmental |
| Auxilliary Outputs: | Automation, External, Console Speaker, and External Alarm Siren |
| Memory: | EEPROM retains system programming during total power failure |
| Operating Temperature: | 32 to 120 degrees F (0 to 49 degrees C) |
|
COMMUNICATOR
|
|
| Dialing: | DTMF or pulse dialing |
| Reporting Formats: | 4 x 2, 20 PPS, or Ademco contact ID |
| Telephone Numbers: | primary,
secondary, and supervisory (paging): Reports: full zone reports, console
reports, general system reports, forced arming, and duress PAC NOTE: paging application uses the supervisory telephone number to access the pager |
| Auxiliary Power: | 12 VDC@ 1 amp maximum for auxiliary devices |
|
HARDWIRE
KEYPAD
|
|
| Indicators: | 24 red zone condition indicators, plus power on, radio, battery, ready, armed, troublem and five system operating mode indicators |
| Built-in Audible: | iezo device for alarm tone (Not to be considered as a substitute for an alarm sounder) keypad and status prompts |
| Keypad Wiring: |
Standard keypad confiquration: 4 wires standard for +, -, data in, data out |
Copyright © 2007 Linear Corporation - All rights reserved