Linear Products Knowledge Base

A.  233 Magnetic Card Reader

B.  233 Programming Keypad

To set up ATM mode on the 233 Access Control System, take the following steps:

1.  Connect one of the included 3 wire harnesses included with the 233 to the Door Ajar connector.

2.  Connect the Green wire from the Door Ajar connector to the White/Orange and White wire on the REX/Door Contact connector on the 233 Programming keypad.

3.  Connect the Blue wire from the Door Ajar connector to the Brown wire on the REX/Door Contact connector on the 233 Programming keypad.

4.  Enter the following commands on the 233 Programming keypad.

    a.  99 # Master Code *   Enters programming mode

    b.  31 # 0 # 1 # * *         Energizes Propped Door (Door Ajar Relay) with any Track II Card

    c.  31 # 2 # 1 # **          Energizes Propped Door (Door Ajar Relay) on card read error

5.   Set an appropriate Main Relay time for your specific needs

Any TrackII magnetic card will now trigger the main relay.