Linear Products Knowledge Base

Programming steps for Quick-Code Wireless Keyless Entry:

Step 1: The red keypad lighting should be off. If it is
on, wait until it turns off (approximately 20 seconds).

Step 2: Using the end of a paper clip, put the receiver of
the MVP into Learn Mode by pressing and quickly
releasing the recessed learn button located on the super
deluxe wall station. The work-lamp on the MVP will
turn on (or blink off then on) to indicate the receiver is
ready to learn a code. You have approximately 30
seconds to enter the keypad pin and door code.

Step 3: Press ON/RESET to turn on the keypad. The
red lighting on the keypad will turn on.

Step 4: Enter your four digit pin. Every time you
press a key the keypad lighting system will blink off and
on to verify a key has been pressed.

Step 5: The work-lamp on the MVP will turn off when a valid pin has been learned. For example, if your four digit pin is "6973," once the MVP is in "LEARN" mode, you would press the following keys: ON/RESET 6973.