Linear Products Knowledge Base

View Articles by Category

Category Icon Standalone Keypad Information (2)
A good starting point for those who do not know much about their IEI Keypad(s).
Category Icon Frontend Keypads (0)
List of IEI Keypads that are current products
Category Icon Prox Pads (2)
< Prox Pad > < Prox Pad Plus > < Stand Alone Keypad / Proximity Reader Access System >
Add an article to this category

Category » Keypadsrss button

< Prox Pad > < 212 series / 232 series / 242 series / 2000 series / Weigand series > < Magnetic Card Reader > < Accessories >

There were 5 articles found in this category:

  1. questionFlashing lights on my device
    What do the flashing lights on my device mean? Most IEI keypads will use the reference below: LED/Sounder Visual/Audible Condition Description Yellow LED Slow Blink Unit is in program mode Rapid Blink Verify mode is active (checking that the last two values in sequence match Steady Program err ...
  2. questionWhy does my ProxPad continue to beep every few seconds?
    To resolve this issue take the following steps. 1. Open the ProxPad and locate the connector labeled P2. 2. Insert the wiring harness with the orange and white wires, into this connector. 3. Tie the white and orange wires together. 4. Connect the orange and white wire to your door contacts.
  3. questionHow do I add/change or delete a user?
    The basic format for adding or changing a user code is (user number # code * code *) where: User Number = the number of the user in the list of users held internally by the keypad. Keypads in the 212 and 232 series have the capacity of 120 users. Users are “numbered” from 1 to 1 ...
  4. questionWhat model keypad do I have?
    Most keypads manufactured by IEI have a label on the inside which has the model number printed on it. It may also help to identify your keypad model by visiting the following web page which, shows most current model keypads sold by IEI: http://www.linearcorp.com/iei_access_solutions.php
  5. questionHow do I setup ATM vestibule mode for the 233 Self Contained Access Control System?
    The 233 Self Contained Access Control System is made up of 2 parts: A. 233 Magnetic Card Reader B. 233 Programming Keypad To set up ATM mode on the 233 Access Control System, take the following steps: 1. Connect one of the included 3 wire harnesses included with the 233 to the Door Ajar conne ...