Linear Products Knowledge Base

Category » Radio Controls For Garage Door Operators

There were 5 articles found in this category:

1. How do I change the keypad code for my Linear garage door operator?
   The Linear series of garage door operators uses the model MDTK keypad, part number DNT00058. This keypad has no memory, and acts only as a transmitter. If you would like to see a diagram with step-by-step instructions and pictures detailing the location of the buttons, please feel free to review ...
2. How do I program my Allstar Quick Code Classic remote?
   The Allstar Quick Code Classic remote can be used with any of the 1, 2, or 3 channel Allstar/Pulsar transmitters and receivers with the same frequency. These are currently available in 288 MHz and 318 MHz. Check the back of the remotes and/or receivers to ensure that they are compatible frequen ...
3. How do I program my MVP remote?
   The MVP remotes come factory programmed with a random code, so, unless you wish to use more transmitters than the receiver will hold, there is no reason to program the MVP remote to any specific code. However, you can do so, if you wish. For 1 channel MVP receivers or MVP operators, select a r ...
4. How do I program my Allstar model 190-104078/TK3500 keypad?
   First, to ensure that the keypad is in the factory mode, reset it by pressing the "on/reset" button, then "999#", "999#". Next, you need to determine your coding switch setting from your Allstar/Pulsar hand held remote. There should be 9 switches (8 in 2 or 3 button remotes). Write down the po ...
5. What transmitter (hand held remote) and keypad will work with my Linear garage door operator?
   The Linear line of operators uses the MegaCode series transmitters and keypads. These are available in many styles, from visor clip to keychain, and can be viewed on our web site in the Entry Systems area under Radio Controls.