My XDM 4600 Central Controller works well by itself, but when connected to the Expansion Hub, the keypads start to flash.
There are three causes to this problem: 1. One cause is when the cable that goes between the Central Controller and the Expansion Hub has come partially loose. Check that this cable is plugged in properly, even screwed down. 2. Another cause is the 4 Zone Expansion Module output on the Ce ...
- Will a local source on my Encore system play throughout the rest of the house?
A local source will only play through the local keypad and speakers. It will not play throughout the rest of the house. If you have additional questions regarding the Encore system, please contact us at video.audio@linearcorp.com.
- Can I use MCS1 or MCS2 keypads when upgrading to an MDS-6A?
MCS1 and MCS2 keypads may not be used when upgrading to a MDS-6A. Only MCS-1A and MCS-2A keypads may be used because the software and pin connection configuration are completely different for the keypads.
- How many MDS6A"s can I connect together?
Two MDS-6A Music Distribution Amplifiers may be connected together using the MDS-PCK Patch Cord Kit. The Model MDS-PCK 6x12 Patch Cord Kit includes six stereo audio breakout cables and six dual-input IR emitters.
- How may Encore hubs can I connect together?
The system can be expanded with up to eight hubs for a total of 32 speaker zones. If you need further assistance, you can either email our Technical Support group at intercom@linearcorp.com or call us at 800-421-1587, Monday – Friday, 6:00am – 4:30pm, PST.
- Why are my LED"s flashing on my XDM46K keypads?
A keypad blinks its red LED's to indicate that it is not communicating with the Central Controller or Expansion Hub. The problem is most always with the CAT-5 cabling or the connector isn't plugged into the Central Controller or Expansion Hub properly. Another cause could be a bad Central Cont ...
