|Home » Categories » Entry Solutions » Garage Door Operators » Specific Garage Door Openers By Brand and or Model » Linear LDO/LSO/LCO|
How do I program my car’s Homelink system to operate my Linear garage door operator?
Article Number: 321 | Rating: 2.3/5 from 29 votes | Last Updated: Tue, Nov 20, 2012 at 12:56 PM
The HomeLink system copies a transmitter that has already been learned into your Linear garage door operator's memory. To learn the transmitter into Homelink, take the transmitter into your car. Press and hold the Homelink button in the car. Press and hold the button on the transmitter that is currently programmed to open your door for 8 to 9 seconds, release only the transmitter button, and immediately press and hold for 8 to 9 seconds. Repeat four to five times, (holding the HomeLink button all of the time) or until Homelink signals that it has learned the code from the transmitter.
There are no attachments for this article.
What transmitter (hand held remote) and keypad will work with my Linear garage door operator?
Viewed 11976 times since Fri, Mar 26, 2010
How do I program my transmitter to my Linear garage door operator?
Viewed 21133 times since Mon, Mar 29, 2010
The remotes will not open my garage door operator from inside or outside the garage, but the remotes will close it. The wall button works correctly.
Viewed 6822 times since Tue, Apr 5, 2011
Can I add a second wall button to my LDO/LSO/LCO series operator?
Viewed 1694 times since Mon, Apr 19, 2010
How do I change the keypad code on my LDO/LSO/LCO operator with serial number after 20100915XXXXX?
Viewed 2232 times since Tue, Apr 5, 2011
What safety beams (photo eyes) can I use with my Linear garage door operator?
Viewed 2738 times since Fri, Mar 26, 2010
How do I change the keypad code for my Linear garage door operator?
Viewed 51590 times since Tue, Jul 12, 2011
How do I change the keypad code on my LDCO800?
Viewed 3138 times since Tue, Apr 5, 2011
How do I adjust the force setting on my Linear garage door operator?
Viewed 3361 times since Fri, Jul 8, 2011
How do I program my MegaCode series keypad into my Linear garage door operator?
Viewed 4009 times since Thu, Apr 15, 2010