|Home » Categories » Multiple Categories|
How do I change the keypad code for my Linear garage door operator?
Article Number: 309 | Rating: 2.8/5 from 22 votes | Last Updated: Tue, Nov 27, 2012 at 11:58 AM
|The Linear series of garage door operators uses the model MDTK keypad, part number DNT00058. This keypad has no memory, and acts only as a transmitter.
In order to change the keypad code, you must erase the memory in the LDO/LSO/LCO. If you will look at the upper right hand corner of the left hand side of the LDO/LSO/LCO, you will see the learn button. Simply press and hold this button for 10 seconds or more. When you release the learn button, the red LED above the button will blink 3 times and then come on bright for 15 seconds. When the LED goes out, the memory in the operator is erased. To learn in a new keypad code, press and release the learn button. The LED will come on for 15 seconds. While the LED is on, go to your keypad and enter your desired code (1 to 6 digits long) and press start/stop on the keypad. The LED will blink to indicate receipt of the new code. You will also have to reenter all of your hand held remotes into the memory.
Again, simply press and release the learn button. When the LED comes on, press the button on the remote you wish to use. Repeat for any additional remotes. If you hold the learn button down for 10 seconds or more, you will have to start over, since the memory will be erased again.
There are no attachments for this article.
How do I find the serial number of my LDO/LSO/LCO operator?
Viewed 1577 times since Thu, Jul 7, 2011
What transmitter (hand held remote) and keypad will work with my Linear garage door operator?
Viewed 12294 times since Fri, Mar 26, 2010
The remotes will not open my garage door operator from inside or outside the garage, but the remotes will close it. The wall button works correctly.
Viewed 7275 times since Tue, Apr 5, 2011
How do I program my MegaCode series keypad into my Linear garage door operator?
Viewed 4091 times since Thu, Apr 15, 2010
How do I program my transmitter to my Linear garage door operator?
Viewed 22436 times since Mon, Mar 29, 2010
How do I set the travel limits on my Linear garage door operator?
Viewed 2482 times since Fri, Mar 26, 2010
The chain is vibrating on my Linear garage door operator when the door is opening or closing.
Viewed 2017 times since Fri, May 14, 2010
What safety beams (photo eyes) can I use with my Linear garage door operator?
Viewed 2824 times since Fri, Mar 26, 2010
How do I program my car’s Lear system to operate my Linear garage door operator?
Viewed 5692 times since Mon, Mar 29, 2010
How do I learn a transmitter into my LDCO800?
Viewed 2461 times since Tue, Apr 5, 2011